Page 1 of 1
Best way of putting on my wheel arches? screw/rivet ?
Posted: Mon Dec 02, 2013 9:33 pm
by cianmini1
thanks
Re: Best way of putting on my wheel arches? screw/rivet ?
Posted: Mon Dec 02, 2013 11:50 pm
by woody
Depends which arches?
If there standard black Rover arches you can get black rivets that look well
Re: Best way of putting on my wheel arches? screw/rivet ?
Posted: Thu Dec 05, 2013 12:36 pm
by keith
and use either plastic or stainless fixings....
Re: Best way of putting on my wheel arches? screw/rivet ?
Posted: Fri Dec 20, 2013 6:27 pm
by danny
3M VHB tape
Re: Best way of putting on my wheel arches? screw/rivet ?
Posted: Fri Dec 20, 2013 10:30 pm
by macker
I've used black self tappers before but they go rusty looking after a little while, you can replace them though as they screw in,
I used stainless silver self tappers this time and they seem to be holding up quite well, haven't changed one yet!.
I've never used rivets as they are a more permanent fixing and if they start to look bad you have to go drilling them out which if you're not careful can lead to problems