Page 1 of 1

Help Needed!!

Posted: Thu Apr 26, 2012 12:45 pm
by mini mad sam
Hi when I'm driving my mini if i brake, slow down or change gear there is a loud bang and a judder from the left side wheel (i think).
I checked engine mountings, they are good.
Any idea what could be wrong??

Thanks.

Re: Help Needed!!

Posted: Thu Apr 26, 2012 1:22 pm
by purplehaze
Could be any thing. I had same prob from mine. My ball joints were Nackered...could be wheel bearings or drop links. Jack the car up an wiggle the wheel hand on top of wheel and other hand on bottom. Pull an push on it. If it wobbles its either wheel bearing drop links or ball joints. Hope this helps

Re: Help Needed!!

Posted: Thu Apr 26, 2012 1:38 pm
by minionly
Drop links???

Re: Help Needed!!

Posted: Thu Apr 26, 2012 2:58 pm
by purplehaze
Minis don't Hav drop links... haha. Honda on d mind haha

Re: Help Needed!!

Posted: Thu Apr 26, 2012 4:24 pm
by woody
wheel bearing, balljoints, trackrod end , tiebar rubbers. Take the wheel off and look.

Re: Help Needed!!

Posted: Thu Apr 26, 2012 4:25 pm
by macker
the bang could be caused by worn engine steadies and the exhaust,
if the steadies are worn when you slow down the engine rocks and lifts the back of the exhaust manifold hitting it off the underside of the car which might be your bang

Re: Help Needed!!

Posted: Thu Apr 26, 2012 9:46 pm
by mini mad sam
found wat was wrong!!
lower tie rod broke where it attaches to the subframe.

Re: Help Needed!!

Posted: Thu Apr 26, 2012 10:14 pm
by Billy
Is the subframe damaged, Sam? I have tie rods and a subframe if you're stuck.

Billy

Re: Help Needed!!

Posted: Fri Apr 27, 2012 5:24 pm
by mini mad sam
hi billy,
it broke where it bolts on to the subframe, just wondering could i weld a new bracket on to the subframe to take the tie rod end?

Re: Help Needed!!

Posted: Sat Apr 28, 2012 4:57 am
by macker
short answer, yes

It is the "L" bracket one that's on the front of the subframe on the drivers side isn't it?

Re: Help Needed!!

Posted: Sat Apr 28, 2012 9:22 pm
by woody
Can you post a picture? Have never seen the subframe break there before, what condition are the rubbers in?