dash
Posted: Tue Oct 21, 2008 11:49 pm
Would anyone have a working drawing for a wooden dash that i could borrow
This any help ?
Downloaded from another forum a few years ago.
Irish Mini Owners Club
Welcome to the Irish Mini Owners Club forum. Celebrating 30 years of the Irish Mini Owners Club, 60 years of the Mini, 50 years of the Clubman and 20 years of our flagship event MTM
https://forum.irishminis.ie/
dash
Page 1 of 1
Re: dash
Posted: Wed Oct 22, 2008 9:14 am
Re: dash
Posted: Wed Oct 22, 2008 9:16 am
Ooooh thats a big pic.
Re: dash
Posted: Wed Oct 22, 2008 6:40 pm
Cheers neil, time to go and make some dusty
Re: dash
Posted: Wed Oct 22, 2008 11:26 pm
those are bout the same measurements i got before from some plans of the net...
i made them to exact measurement but found it wasnt a perfect fit... (no offense tmg)
if i was you joe id make it slighlt bit bigger than given measuremnts, better to big than to small.......
good luck making one joe..
steven
i made them to exact measurement but found it wasnt a perfect fit... (no offense tmg)
if i was you joe id make it slighlt bit bigger than given measuremnts, better to big than to small.......
good luck making one joe..
steven
Re: dash
Posted: Wed Oct 22, 2008 11:57 pm
Just go out and use tape, and get creative.
Re: dash
Posted: Thu Oct 23, 2008 1:44 pm
cheers lads, i ll make it an exact fit and post up the exact drawin,
Re: dash
Posted: Thu Oct 23, 2008 7:21 pm
I have my old dash here and the measurements in the drawings are nearly the same, the difference is that i made up
top rail myself so the height is different.Length and angle are same.
top rail myself so the height is different.Length and angle are same.