Welcome to the Irish Mini Owners Club Forum. Celebrating 30 years of the Irish Mini Owners Club, 60 years of the Mini and 50 years of the Clubman

CV Joint seating washer

Welcome to the Techinical of the IMOC.

The Irish Mini Owners Club and its officers provide this service as a service to its members and Mini enthusiasts in good faith and do not endorse or confirm any detail or claim pertaining to items posted by individuals using this forum.

Moderators: irishminis, spud1979, The Marcos Graveyard, admin, woody, Moderators

Post Reply
charcosull
NON Member
Posts: 41
Joined: Sun May 15, 2011 10:56 pm
Whats your location?: Dublin
Region: Eastern
Contact:

CV Joint seating washer

Post by charcosull » Thu Jun 13, 2019 10:23 am

Hi All.
Would anybody know the dimensions of the seating washer to torque up the cv joint/front wheel bearing (tool21 on minispares).

Or even better, does anybody have one that they could lend me for a day?

Thanks
Ciaran



User avatar
Fatman
IMOC Paid Member
Posts: 23
Joined: Mon May 09, 2005 9:28 pm
Location: Dublin
Contact:

Re: CV Joint seating washer

Post by Fatman » Sat Jun 15, 2019 3:49 pm

There is a drawing & description in your Haynes Manual in the chapter on 'Driveshafts'. It is cut from 1/4in. - 6.5mm sheet steel or a washer with a Diameter of 50mm & a centre hole of 25mm. Don't use anything thinner as you will not be able to pull the CV joint tight. Eamonn.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests