Page 1 of 1

SUSPENSION CONE COMPRESSOR TOOL

Posted: Sat Apr 23, 2016 10:30 am
by keith
Looking for a loan of this, for a few hours. Need a metric type, for a later mini. I'm in Dublin and can collect. Keith 086 3169291

Re: SUSPENSION CONE COMPRESSOR TOOL

Posted: Fri Nov 30, 2018 7:04 pm
by Richmond Classics
Hi

If you were to fit HiLo,s, You may not need a tool to compress the cone.

Simply put the HiLo at the lowest point and you should be able to re-install without a compressor. HiLo take up all the slack as the car goes down over the years as well

Removal will be pretty easy as there is no spring left in the cone, so simply un-screw the top arm bolt, remove the pin and everything should fall away.

Re: SUSPENSION CONE COMPRESSOR TOOL

Posted: Fri Nov 30, 2018 8:16 pm
by keith
Neil, thanks. k.

Re: SUSPENSION CONE COMPRESSOR TOOL

Posted: Sat Dec 01, 2018 7:55 pm
by The Marcos Graveyard
Getting it out in the first place may be a bit difficult without one.

Have one here if it's of any use to you Keith.

Re: SUSPENSION CONE COMPRESSOR TOOL

Posted: Sat Dec 01, 2018 8:13 pm
by keith
Thanks Neil. I'm sorted. - i put in coil replacements. :)