Irish Mini Owners Club

vice grips must alot cheaper to buy in bulk I agree with Billy at this rate it would be ready for MTM

[quote="The Marcos Graveyard"]Jaysus, you're not hangin' around Joe. [/quote]
ah no time like the present Yu right u cant beat a half dozen Vice-Grips
(i sent an email to simon to register but no look yet any ideas,jason?)
[quote="DaveC"]Nice work. When can I drop in my GT???[/quote]
If you have the money Dave Ill make the time


ill be on the mtm this year but i dont think in this mini

Joe/Jason,

What ye're doing is only magic! Fair play to ye. My only attempt at welding was on a AnCo (pre-FAS) course 25 years ago and all I did was stick welding rods to metal. It's great ye can do the work yourselves.

Keep up the good work,

Billy

Take it easy Joe if you finish this year you will have to put the full tax on it,next year its due for the vintage.I have to say that clubmans with black arches are just the dogs danglies.I have something in the pipeline that will please all ye clubman fans out there. By the way does anyone know if that crewes missile mini is an original mini colour,I have a vague recollection of this car being a feature car in one of the mags.This is a fantastis car but I,d love to see it on a set of 10,s old skool.

[quote="Billy"]Joe/Jason,

What ye're doing is only magic! Fair play to ye. My only attempt at welding was on a AnCo (pre-FAS) course 25 years ago and all I did was stick welding rods to metal. It's great ye can do the work yourselves.

Keep up the good work,

Billy[/quote]
ah no worries, the trick to welding is to pick up a welder and just start! and stick at it......im at it about 2 weeks now

4 holes instead of 6

Jason, It's a ringer

holy crap thats some great progress (and amazing welding skillz)



keep it up boys!!

getting rid of the rot...gradually, though its nearly all gone now tg

think'n of doing a deal with joe for his 12" deep dish

Don,t do it,stick with the tens,there is enough of them big wheel brigade about.Super progress by the way.

Another step closer another one to go the far side

had to weld in a couple of right angle pieces to steady the panel inside the boot but pritty happy with the outcome

hope ye are not getting fed up looking at pictures if so stop me now!!!!!!(what do ya think of ur whels joe )

Keep up the good work, you will be finished in no time

so, just a little update on the progress, iner sills, step and outer sills all fitted and welded up on both sids now. some pics of before and after of the passenger side and a small piece of metel on the A panal to do away with the rust all it need is a skim of filler:lol:

started on drivers floor tonite

Bit of a clear out for the time being...thanks for the lift dad!!!

You're not dumping all those valuable bits !!!!!

Joe you could have at least covered up the company logo.

Are those yellow ESB Networks a subsidary of the AA, they seem to feature a lot towing minis.Great work on the clubman although health and safety may have somthing to say about your two post lift

No TMG .Just moving them to a different home! Though none of these lumps are going into the clubman always handy to
have spares especially with 2 minis to look after![they are going out to keep the Metro company]
kerryninigringo...he just reversed up behind the trailor!
woody..he never towed it anywhere..u can't beat a good towbar though

cold air vents welded up on the drivers side like wise on the other side

repairs completed to both door pillers

before and after of the repair to the roof gutter