Welcome to the Irish Mini Owners Club Forum. Keep an eye out of on coming events!!!!

CV Joint seating washer

Welcome to the Techinical of the IMOC.

The Irish Mini Owners Club and its officers provide this service as a service to its members and Mini enthusiasts in good faith and do not endorse or confirm any detail or claim pertaining to items posted by individuals using this forum.

Moderators: spud1979, The Marcos Graveyard, admin, woody, Moderators

Post Reply
charcosull
NON Member
Posts: 42
Joined: Sun May 15, 2011 10:56 pm
Whats your location?: Dublin
Region: Eastern
Contact:
Contact charcosull

CV Joint seating washer

Post by charcosull »

Hi All.
Would anybody know the dimensions of the seating washer to torque up the cv joint/front wheel bearing (tool21 on minispares).

Or even better, does anybody have one that they could lend me for a day?

Thanks
Ciaran


Top
User avatar
Fatman
IMOC Paid Member
Posts: 24
Joined: Mon May 09, 2005 9:28 pm
Location: Dublin
Contact:
Contact Fatman

Re: CV Joint seating washer

Post by Fatman »

There is a drawing & description in your Haynes Manual in the chapter on 'Driveshafts'. It is cut from 1/4in. - 6.5mm sheet steel or a washer with a Diameter of 50mm & a centre hole of 25mm. Don't use anything thinner as you will not be able to pull the CV joint tight. Eamonn.
Top
charcosull
NON Member
Posts: 42
Joined: Sun May 15, 2011 10:56 pm
Whats your location?: Dublin
Region: Eastern
Contact:
Contact charcosull

Re: CV Joint seating washer

Post by charcosull »

Eamonn you absolute gentleman. I moved house and couldnt find the Haynes manual anywwhere. Probably still at the bottom of a box.
I was able to get a very very similar sized washer in Tripart in galway this morning. Thanks again. Should be back on the road in the morning.

Ciaran
Top
Post Reply

Return to “Technical Section”

Who is online

Users browsing this forum: No registered users and 2 guests