I've discovery some rust on the front floor panels and the sills.
If I replaced the floor panels would I need to replace the inner sills too,
http://www.minispares.com/product/classic/MS25R.aspx
or does this panel include the sill?
Has anyone used this panel from mini spares before?
Is it hard to fit?
Here's a few photos of the rust, any recommendations on what to do would be great!
Welcome to the Irish Mini Owners Club Forum. Keep an eye out of on coming events!!!!
body work, welding question.
Moderators: spud1979, The Marcos Graveyard, Moderators
-
- NON Member
- Posts: 360
- Joined: Thu Jun 11, 2009 11:55 pm
- Whats your location?: Firhouse
- Region: Eastern
- What Minis have you?: '90 mini 998cc
- Modifications: Straight through exhaust, bucket seats stage 1, 12x6 matt black revo's, matt black paint job(work in progress)
- Location: Firhouse
- Contact:
- purplehaze
- NON Member
- Posts: 990
- Joined: Wed Mar 30, 2011 2:42 pm
- Whats your location?: Tallaght :p
- Region: Southern
- What Minis have you?: 1980 clubman b16 vtec
1992 mini shell, getting turbo,d
1974 clubman estate - Modifications: original-ish pffffft ye rite
- Contact:
Re: body work, welding question.
As far as I know! U just need that panel then the out sill!!! There are still the doorsteps! And if the driver side is like that be sure to check the others side!!! Strip ur interior and check back, sides! An front on both driver and passenger sides!!! Check ur door hinge inanely also an boot floor coz If your floors are like that there cud be hidden treasure everywhere
If it's bigger than a mini it's not a mini
-
- NON Member
- Posts: 360
- Joined: Thu Jun 11, 2009 11:55 pm
- Whats your location?: Firhouse
- Region: Eastern
- What Minis have you?: '90 mini 998cc
- Modifications: Straight through exhaust, bucket seats stage 1, 12x6 matt black revo's, matt black paint job(work in progress)
- Location: Firhouse
- Contact:
Re: body work, welding question.
The rest of the body seams fine, the only places that seem to be bad is the sills and around the air vents, I plan on blanking these off.
-
- NON Member
- Posts: 360
- Joined: Thu Jun 11, 2009 11:55 pm
- Whats your location?: Firhouse
- Region: Eastern
- What Minis have you?: '90 mini 998cc
- Modifications: Straight through exhaust, bucket seats stage 1, 12x6 matt black revo's, matt black paint job(work in progress)
- Location: Firhouse
- Contact:
Re: body work, welding question.
I've cleaned down the floor pans and out sills.
When I'm replacing these panels which one should i do first?
And do I need to brace the door, remove subframes?
When I'm replacing these panels which one should i do first?
And do I need to brace the door, remove subframes?
-
- NON Member
- Posts: 360
- Joined: Thu Jun 11, 2009 11:55 pm
- Whats your location?: Firhouse
- Region: Eastern
- What Minis have you?: '90 mini 998cc
- Modifications: Straight through exhaust, bucket seats stage 1, 12x6 matt black revo's, matt black paint job(work in progress)
- Location: Firhouse
- Contact:
Re: body work, welding question.
anyone?
Who is online
Users browsing this forum: No registered users and 0 guests