Any wiring gods??

[stevie g]

My indicators just stopped working,I just replaced the flasher but to be sure I got a new one,no joy
my hazards work so I'm thinkin it may be the stalk? Any ideas?
Thanks

[yellowminiman]

did you check the two inline fuses under the scuttle panel behind carb

[92Coop]

also stevie, if that doesnt work, unscrew all indicator surrounds and check for water ingress.
i had terrible trouble with indicators on my old cooper, and it was all down to corroded contacts
within the light itself. backs of the bulbs were covered in rusty gunk. a quick sandpaper job and
i was right as rain.

[stevie g]

did you check the two inline fuses under the scuttle panel behind carb

I can only find one fuse there???

[miniireland]

did you re connect the 2 wires that you snapped off the spade for the flasher unit ,give the plugs under the steering column a wiggle they are notorious for loose connections....

[clubmankev]

The hazard switch is a possible culprit.

[stevie g]

did you re connect the 2 wires that you snapped off the spade for the flasher unit ,give the plugs under the steering column a wiggle they are notorious for loose connections....

yea I sorted that,had it working and all

[stevie g]

The hazard switch is a possible culprit.

sound,I'll look at that in the morn

[miniireland]

The hazard switch is a possible culprit.

sound,I'll look at that in the morn

did you get the correct flasher unit ,the hazard problem only happens on cars that dont have functioning hazard lights, i.e if you leave the hazard light switch in the on position it overides the indicators at the stalk, but this particular car has functioning hazard lights, try putting the old unit back in, also the plugs under the steering column open and clean the contacts aswell

[stevie g]

I got the multimeter on it today,I think it might be the stalk

[woody]

There are two seperate flasher units for hazard and indicator. What year car is this?