next project comming soon

Post by **jd's mini** » Sat Sep 05, 2009 10:52 pm

Post by **StanO'Toole** » Sat Sep 05, 2009 10:58 pm

Is that like an outer skin roll bar? The body doesn't look bad, I'd say facing it its a different story!

StanO'Toole

Post by **jd's mini** » Sat Sep 05, 2009 11:16 pm

no theres a lot a work in this when you do it on your own.i posted up a front view

Post by **StanO'Toole** » Sat Sep 05, 2009 11:33 pm

It's a bit different when you look head on!

StanO'Toole

Post by **jd's mini** » Sat Sep 05, 2009 11:40 pm

go back in stan and see do ya remember this clubman

Post by **StanO'Toole** » Sat Sep 05, 2009 11:43 pm

I do indeed JD, that was for sale for a ferce almost of time and was seriously price reduced! What are your plans for it?

StanO'Toole

Post by **jd's mini** » Sat Sep 05, 2009 11:48 pm

7 inch arch"s 1275 engine translusent green buckets ill post ya pm for a pic of the body kit

Post by **StanO'Toole** » Sat Sep 05, 2009 11:51 pm

Thanks dude, I would really like to follow this clubbie up

StanO'Toole

Post by **StanO'Toole** » Sat Sep 05, 2009 11:58 pm

HOLY F**K

StanO'Toole

Post by **jd's mini** » Sun Sep 06, 2009 12:00 am

fine job aint it

Post by **StanO'Toole** » Sun Sep 06, 2009 12:02 am

To right!!!! That is going some different!!! What will be first to start? The clubbie or the pick-up?

StanO'Toole

Post by **jd's mini** » Sun Sep 06, 2009 12:08 am

no the clubby the engine is comming out tomo id reckin 2 months on the body work and engine

Post by **StanO'Toole** » Sun Sep 06, 2009 12:13 am

And will the 1275 be standerd or do you have some phyco plans to go with the body kit?

StanO'Toole

Post by **jd's mini** » Sun Sep 06, 2009 2:12 am

dont no im kepping my eyes open might go for something bigger

Post by **StanO'Toole** » Sun Sep 06, 2009 2:15 am

Like a 1480cc or a 1600 V-tec?

Personally I think you should go -tec, it would match that kit your getting

StanO'Toole

Post by **jd's mini** » Sun Sep 06, 2009 2:33 am

i was thinking v tec i posted up the pickup shell she"s a minus 3"s lower than a normal mini

Post by **StanO'Toole** » Sun Sep 06, 2009 12:21 pm

V-tec would be preety class! Those sub-frames are bloody expensive though!

StanO'Toole

Irish Mini Owners Club