Hello,
Mini floors could do you some care, what are the best products to use on them to seal them and where can I get them?
How do you know if they should be replaced or not??
i also need some rubber seals for the engine bay are these just generic ones or should i get ones specific for minis?
Thanks
Welcome to the Irish Mini Owners Club Forum. Keep an eye out of on coming events!!!!
Floors
Moderators: spud1979, The Marcos Graveyard, Moderators
- The Marcos Graveyard
- IMOC Paid Member
- Posts: 4720
- Joined: Fri Feb 04, 2005 10:05 am
- Whats your location?: Longford
- Region: Eastern
- What Minis have you?: 1971 Mini Marcos.
1984 Mini Sprite - Modifications: 1380cc
Weber45
S/C CR gearbox and drop gears - Location: Longford
- Contact:
Re: Floors
Is it just surface rust or are the floors holed ?
Once you clean the crud up, you can clean any rusty metal with a wire brush, you can use a seam sealer where needed, then clean and cover with a coat of zinc primer, finish with the colour of your choice.
You can use any suitably sized grommet for the engine bay, I would suspect that OE ones are not available, but you could try Somerford Mini, they do a lot of restorations and if anyone has them then they would.
Once you clean the crud up, you can clean any rusty metal with a wire brush, you can use a seam sealer where needed, then clean and cover with a coat of zinc primer, finish with the colour of your choice.
You can use any suitably sized grommet for the engine bay, I would suspect that OE ones are not available, but you could try Somerford Mini, they do a lot of restorations and if anyone has them then they would.
Re: Floors
hello,
No holes that I have spotted yet anyway!! It all appears to be surface rust so far. thanks again for the advice, much appreciated.
Any particular brand you would recommend using on the floors??
No holes that I have spotted yet anyway!! It all appears to be surface rust so far. thanks again for the advice, much appreciated.
Any particular brand you would recommend using on the floors??
Who is online
Users browsing this forum: No registered users and 1 guest