can someone just verify before i remove the carb..
is the jet needle that attches to the float on all hif carbs the same??
mine was broke on the hif38 so i switched the one from a hif44 carb onto it, which as result after many cancelations could be where the fault lies as to why my engine stalls on deceleration
thanks
Welcome to the Irish Mini Owners Club Forum. Keep an eye out of on coming events!!!!
carb prob... again........
Moderators: spud1979, The Marcos Graveyard, Moderators
-
just_st3v3n
- NON Member
- Posts: 785
- Joined: Wed Mar 01, 2006 11:22 am
- Whats your location?: cavan
- Region: Northern
- What Minis have you?: 1989 red mayfair aka project nancy
- Modifications: Nancy is deseamed and will be getting some sort of modern engine someday
- Location: cavan
- Contact:
-
The Marcos Graveyard
- IMOC Paid Member
- Posts: 4720
- Joined: Fri Feb 04, 2005 10:05 am
- Whats your location?: Longford
- Region: Eastern
- What Minis have you?: 1971 Mini Marcos.
1984 Mini Sprite - Modifications: 1380cc
Weber45
S/C CR gearbox and drop gears - Location: Longford
- Contact:
Re: carb prob... again........
The jet and the needle are two different things, the jet is the hole in the middle of the carb that the needle goes into, the needle is the bit that attaches to the piston in the top of the carb.
Needles come in different profiles and are stamped with the profile code on the fatter part of the needle.
What oil have you in your dashpot ?
Needles come in different profiles and are stamped with the profile code on the fatter part of the needle.
What oil have you in your dashpot ?
A fully carbon fiber Mini Marcos shell weighs just 7.25kg.
Who is online
Users browsing this forum: No registered users and 1 guest
