Welcome to the Irish Mini Owners Club Forum. Keep an eye out of on coming events!!!!

engine wont stop

General MINI related posts. Open to all, registration required

Moderators: spud1979, The Marcos Graveyard, Moderators

Post Reply
Tim Urry
NON Member
Posts: 51
Joined: Fri Aug 31, 2007 8:05 pm
Contact:

engine wont stop

Post by Tim Urry »

i recently put in a new 1380 and it runs fine until i turn off the key then it cotinues to run very badly then fires up again before turning off. this does not look or sound to cool. i think it might be the carb that is the problem as that came off my brothers cooper and he somtimes had the same problem. does anyone have a solution

Thanks :)


User avatar
mustard
NON Member
Posts: 1111
Joined: Wed Jan 03, 2007 1:11 pm
What Minis have you?: 97 rover cooper sportspack, a bloody metro and MY 61 mini van
Location: athboy, co. meath
Contact:

Re: engine wont stop

Post by mustard »

timing is out i think...
If ya can't fix it with a hammer, its an electrical problem!

J & A Commercials and Auto Repairs ltd.
From Minis to Trucks, everything and anything
Clondalkin Dublin 22
Contact Mick: 0868526492 or 014578687
User avatar
Merlin
NON Member
Posts: 491
Joined: Thu Sep 07, 2006 11:05 pm
What Minis have you?: Mk1 Austin Mini,Mk3 Layland Mini,72Van,81 Clubman Estate, 87 Race carand a 2000 Rover Cooper.
Modifications: Mk1: 998 with flat top slipper pistons, 286 cam, 12G940 head 11:1 compression twin inch and a half SU's 5 speed gearbox. Mk3 998 automatic no mods, 72Van is a pile of rust, , Racer is being built but has the works and the 2000 rover cooper needs an engine again :(
Location: Dublin
Contact:

Re: engine wont stop

Post by Merlin »

It can be one of many things:
1: lean burn causing to high a combustion temperature (very bad news needs to be sorted ASAP)
2: Over advanced Ignition also bad news needs sorting ASAP
3: Crab butterfly not closing totally no major big but a good idea to sort before causing a bigger problem
3: to rich a mixture causing deposits on the head which glow red hot when the Ignition is switch off igniting the incoming fuel and air mixture
4: vacuum leak check all pipes.
So how do you go about finding where the problem is?
First take out a plug if it is sooty and black most like hood is your mixture is rong (bring the car to a rolling road have it setup right)
If the plug is white or has no colour then it is most like running lean same as before rolling road
one very simple test to try to see if its ignition advance that is your problem is just as you turn the ignition of press the throttle if the engine does not run any more than normal then its ignition if it runs on less then it like to be a vacuum leak or a sticky throttle butterfly.
User avatar
woody
IMOC Paid Member
Posts: 2837
Joined: Mon Feb 07, 2005 11:55 pm
Whats your location?: Drogheda
Region: Eastern
What Minis have you?: Traveller
Turbo
Hornet
Equinox
MINI Clubman
Location: LOUTH
Contact:

Re: engine wont stop

Post by woody »

Have you had any tuning done on the engine? What dizzy are you using?
Like Merlin says it sounds like mixture or timing or both.It could distroy your new engine if not sorted soon.
User avatar
The Marcos Graveyard
IMOC Paid Member
Posts: 4724
Joined: Fri Feb 04, 2005 10:05 am
Whats your location?: Longford
Region: Eastern
What Minis have you?: 1971 Mini Marcos.
1984 Mini Sprite
Modifications: 1380cc
Weber45
S/C CR gearbox and drop gears
Location: Longford
Contact:

Re: engine wont stop

Post by The Marcos Graveyard »

Sounds like Run-On, no doubt caused by one or more of the reasons highlighted by Merlin, it needs sorting sooner than later as it can cause major damage, learn to stop the car in gear as good habit but get the engine looked at soon.
Image

A fully carbon fiber Mini Marcos shell weighs just 7.25kg.
Tim Urry
NON Member
Posts: 51
Joined: Fri Aug 31, 2007 8:05 pm
Contact:

Re: engine wont stop

Post by Tim Urry »

Thanks for the help. I have not done any tunning to the engine and the dizzy is made by aldon. Does anyone no of a mini friendly rolling road in cork that i could take it to.
User avatar
The Marcos Graveyard
IMOC Paid Member
Posts: 4724
Joined: Fri Feb 04, 2005 10:05 am
Whats your location?: Longford
Region: Eastern
What Minis have you?: 1971 Mini Marcos.
1984 Mini Sprite
Modifications: 1380cc
Weber45
S/C CR gearbox and drop gears
Location: Longford
Contact:

Re: engine wont stop

Post by The Marcos Graveyard »

The only one I know of in Cork is

Des Golden Services,
Unit 4 Karlbrook Enterprise Park
Doughcloyne Industrial Estate,
Sarsfield Road,
Wilton.
Cork.
021 4867888

Having never used them I cannot comment on their work I'm afraid.
Image

A fully carbon fiber Mini Marcos shell weighs just 7.25kg.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests