Welcome to the Irish Mini Owners Club Forum. Keep an eye out of on coming events!!!!

1983 Mini City

This section is for Mini projects and restorations and also the place to show off your pride and joy.

Moderators: spud1979, The Marcos Graveyard, Moderators

User avatar
colinf1
NON Member
Posts: 461
Joined: Mon Aug 24, 2020 10:27 am
Whats your location?: Dundalk
Region: Eastern
What Minis have you?: 1983 Mini City 1000
Contact:

Re: 1983 Mini City

Post by colinf1 »

Last show of the year for me, the indoor car show at Laois Shopping Center, a round trip of 336km / 208 miles. Total journey time of just under 4 hours with a quick toilet stop.

Drive down had a few hiccups, drivers side wiper blade tried to escape, the little tab on the end had worked it's way out from the arm. Just needed pushing back in and ensuring clips were secured. Then indicators stopped working, tried reseating the flasher unit, but no joy so had to continue on and hope that it wasn't too busy at the M50/N7 junction, which thankfully it wasn't. I reseated it again at the services and they started to work...that's another job for the winter list.

Show was good, but very cold, hard to keep the 14 Month old from pulling his hat and gloves off! A great selection of cars, and a good showing from the club.

Drive home was constantly raining, passenger side mat is very wet now from the rain working it's way in, again another winter job to fix - it's either the wiper arm bush or the blanking plate on LH side that doesn't have a gasket on it. A liberal amount of sealant should sort it out.

I'll more than likely remove the front carpet and underlay to make sure it not wet all winter.

Image

Image

Total mileage is now 3686km, not a bad effort.


Image
ctwomey
NON Member
Posts: 313
Joined: Thu Jan 03, 2019 9:44 am
Whats your location?: Ballybrittas, Co. Laois
Region: Eastern
What Minis have you?: I owned a 1978 Mini 850 when I was in my late teens. I owned a 1986 Mini Chelsea that I imported from the UK. Also owned a 1982 MG Metro that was bored out to 1293. Restoring a 1981 Dublin Mini City.
Contact:

Re: 1983 Mini City

Post by ctwomey »

Great to see you Colin. Your mini was looking fab! Glad you made it home too as that was some round trip with the young fella. I think my gang are starting to get excited about my own project now. So no pressure then...
User avatar
colinf1
NON Member
Posts: 461
Joined: Mon Aug 24, 2020 10:27 am
Whats your location?: Dundalk
Region: Eastern
What Minis have you?: 1983 Mini City 1000
Contact:

Re: 1983 Mini City

Post by colinf1 »

A tight squeeze...

Image

A quick stop under the cover of the lean-too patio roof, awaiting a underbody wash and air dry..

Image

Removed the front carpets, a fair bit of water in the underlay, thankfully the floor is relatively dry, but will leave the windows open to let the air circulate.

Image

Image
Image
User avatar
colinf1
NON Member
Posts: 461
Joined: Mon Aug 24, 2020 10:27 am
Whats your location?: Dundalk
Region: Eastern
What Minis have you?: 1983 Mini City 1000
Contact:

Re: 1983 Mini City

Post by colinf1 »

Started the underside clean down, got drivers front and rear done.

Image

Noticed the bushing was loose on the rear shock, that would explain the knocking noise that came on on the last drive home. I thought it was the child's buggy wheels that I had in the boot.

Image

There are a few bits of tar and a few small stone chips, mainly just on the flitch panel, but I'm very happy with how clean it is and how well all the paintwork is holding up, both the body paint/raptor stonechip and the brushed on hammerite on the suspension parts.
Image
User avatar
colinf1
NON Member
Posts: 461
Joined: Mon Aug 24, 2020 10:27 am
Whats your location?: Dundalk
Region: Eastern
What Minis have you?: 1983 Mini City 1000
Contact:

Re: 1983 Mini City

Post by colinf1 »

Got the passenger side cleaned up today, this side was a bit dirtier as expected, but thankfully no signs of any cv joint grease from the split CV boot on this side. Also checked the rear shock absorber top bushes, but these seem fine with no movement at full droop.

Gave it a quick wash overall then into the shed.

Will make a list of jobs that I want to get done over the winter, then hopefully get all the required parts on the minispares black Friday sale...no doubt there'll be something I'll need a week after getting my order!

Image
Image
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests